T8 to T5 Tube Light Convertor Fittings 

 Product Material

Fixture Body Material: 0.3mm Thickness Aluminum, Choice of WHITE POWDER COATED, MATTE or LUSTRE;

Lamp Holder: Anti-flaming PC Lamp Holder, which can be fit for both vertical, 90 degrees, and horizontal, 180 degrees, installation;

Ballast: Electronic ballast, rapid start or pre-heat start

Ballast choice available:

1). IC Standard, PF≥0.99, THD<10%, rated life is 30,000h;

2). TUV Standard, PF≥0.98, THD<15%, rated life is 20,000h;

3). High Standard, PF≥0.92, THD<30%, rated life is 15,000h;

4). Normal Standard, PF≥0.55, rated life is 15,000h;

Tube: T5 Tri-Phosphor Fluorescent lamp, Ra≥82, rated life ≥10,000h, color temp. of 2700K-9000K.

Aluminum reflector and nano anti-oxidation film: the light is brighter, more concentrated, luminous efficiency improvement

 Installation Details

Process

1. Turn off the power and remove the t8 tubes;

2.  Remove the t8 starter;

3. Install the t5 convertor fixtures

Main Application

Be applicable to various locations such as offices, shopping malls, supermarkets, garages, schools and workshops, ect.

Description of T5 Adaptor

1) Slim Design: integrated built-in electronic ballast, modern design;

2) Easy Installation: can be directly applied to the traditional T12/T10/T8/T6 fluorescent lamp fixtures, no electrician required;

3) Energy Efficient: adopt high efficacy T5 tri-phosphor fluorescent tubes, can save up to 45% electricity, while increase lumens output by 10%;

4) Pre-heat functions: enable the tube to start without flickering and extend the whole system's life;

5) Environmental Friendly: use solid-stated mercury, easy to recycle, 38% less usage of glass and phosphor powder compared to T8 lamps.

6) Higher Color Rendering Index: 10% improvement in reproducing the color of the subjects.

7) Eye Protecting: T5 Adaptor adopts the electronic ballast, of which the frequency is 30KHz to 50KHz, so there is no stroboscopic effect, which can alleviate the eye fatigue dramatically. In contrast, the traditional T8 or T9 lamp uses the magnetic ballast, of which the frequency is 60Hz, and there are obvious stroboscopic effects.

8) Rapid Payback: Low initial cost, rapid pay back since converting existing luminaries is a fraction of the electricity cost that is saved;